Home > Electronics >

AEM Version 2 ECU PNP for JZX100/JZZ30 VVTi 1JZ-GTE
AEM Version 2 ECU PNP for JZX100/JZZ30 VVTi 1JZ-GTE


 
Additional Views:


Our Price: $1,399.00
Part Number: AEM Version 2 ECU PNP for JZX100 VVTi 1JZ-GTE


Availability:: Usually Ships in 5 to 7 Business Days
Product Code: DM3006
Qty:

Description
 
AEM Version 2 ECU PNP for JZX100/JZZ30 VVTi 1JZ-GTE. This is a brand new Version2 AEM standalone, and a plug and play 1JZ-GTE adapter harness that fits the JZX100 engine harness and some other VVTi 1JZ-GTE engine harnesses that have 4 ecu connectors with 4 rows of pins. (please see the picture of the ECU connector type this standalone works with). A stock 1JZ basemap will be included with this unit. You must switch to a MAP sensor and add an air temp sensor, this unit is not set up to run an air flow meter. The only real limitation of this ecu are that it can only run high impedance injectors directly, but it can run low impedance injectors if a injector resistor is used. It is wired to control the factory idle speed control motor. This unit has 6 injector drivers, and 6 ignition drivers, but it can not run ignition coils directly without the use of a factory or aftermarket igniter. It is ONLY FOR MANUAL TRANSMISSION vehicles, it has no controls for an automatic transmission. We make the harnesses here in house, which is why we have a shipping time of 5-7 business days. We spent a LOT of time and money ironing out everything needed to make this happen at this price. Just about every dyno shop in the USA can tune AEM, so you will have no problem getting this unit tuned. Please call Aaron at 909-753-7385 if you have any specific questions about this item, thanks!

Please make sure you are selecting the correct version for your engine harness BEFORE placing an order. We don't offer exchanges or refunds on this item.

Share your knowledge of this product. Be the first to write a review »