Home > 1JZ & 2JZ Swap Parts >

Driftmotion Adjustable Throw R154 Shifter
Driftmotion Adjustable Throw R154 Shifter


 
Additional Views:


Our Price: $299.00
Part Number: Driftmotion Adjustable Throw R154 Shifter

Availability:: Back Ordered
Product Code: DM3460


Shifter Version*:


Shifter Socket (bottom tip)*:


Shift Knob*:


Spacer with Bolts*:


Rubber Boot with Clamps*:


Qty:  
Description
 
** BACK ORDERED. ** Straight and angled versions available.

NEW Driftmotion Adjustable Throw R154 Shifter, and "Spline-Drive" adjustable angle and adjustable throw shifter.
This is an item we have been working on for a while, and we are proud to be able to offer it to you! These shifters have a variable pivot point, allowing you to go from short throw to medium throw. We accomplished this by threading the pivot ball, and including a spacer. We have an option for a straight or angled lever on our Adjustable Throw Shifter. We also addressed the common issue of leaking R154 shifters by integrating an o-ring into the shifter housing and the spacer. We include a rubber boot and clamps to completely seal oil in, and dirt out. These shifters are made in the USA, using 304 stainless, and 6061 aluminum, with radiused aluminum-bronze alloy bushings. The shifting feel is very smooth and precise. If you did a shifter extension and it isn't quite aligned correctly in the housing, this lever can be adjusted up/down to compensate for it. We made the 12mm x 1.25 threads extra long at the top, so if you prefer a shorter lever you can cut it down. The length is about the same as a stock MK3 Supra shift lever. On the "Spline-Drive" model shifter, you can change the angle of the lever from straight up, to almost 45 degrees. We used high strength 300M steel for the splined pin, which gives you adjustability without sacrificing durability.

*The Adjustable Throw and Spline-Drive shifters both include a spacer and two different bolt lengths, to give you short or medium throw.

*Both shifter versions include a rubber boot with clamps.

*A Marlin Crawler shifter socket is optional, but recommended. If you already have a socket you can select "NO Shifter Socket Included"

*Our delrin shift knob is optional, but its a nice option for the money! Otherwise any 12mm x 1.25 shift knob can be used.

*SC300 and MK4 Supra with a typical 4.75" shifter extension usually works best with the straight lever version, MK3 Supra and many other vehicles would usually be best with the angled lever.

*These shifters are for the R154 from the MK3 Supra, and early Soarer, they will not fit tripod R154 versions, These shifters will also fit W58 transmissions from the MK3 Supra.



Share your knowledge of this product. Be the first to write a review »